Page 1 - PACE Catalogue

BGA Rework

InfraRed

PACE’s InfraRed Systems can easily install and remove IR3100
BGA, QFN, µBGA/CSP, Flip Chip and other SMD’s. PN: 8007-0586 (120 V), 8007-0587 (230 V)
Featuring a 500W infrared (IR) top heater and a 1000W IR
bottom preheater, the IR3100 does not require nozzles. A The IR3100 includes 1550
specially-developed IR pyrometer provides non-contact, Watts of total power. Can
real-time, closed-loop temperature control throughout rework PCBs up to 12” x 12”
the reflow process. A Sodr-Cam Reflow Camera comes (305mm x 305mm). Includes
standard, allowing you to watch the entire reflow process an 1000 Watt bottom side
in real time. The IR 3100’s newly designed Windows-based pre-heater with an adjustable
software makes profiling incredibly simple for even the most height of 1.5” (38mm). Also
advanced applications, providing intuitive set-up, multi- comes with 6 different sized
stage profiling, on-the-fly profile adjustment, flux-dipping, vacuum picks.
unlimited profile storage and much more.

IR4100
PN: v (120 V), 8007-0592 (230 V)
The IR4100 includes 2400
Watts of total power. Can
rework PCBs up to 24” x
24” (610mm x 610mm).
The bottom-side pre-heater
includes a 1000 Watt central
heater and (6) 150 Watt
The Closed-Loop, Non-Contact IR Pyrometer
monitors and controls the ramp-rate and temper- periphery heaters that can be
ature of the component in real time, by controlling independently controlled.
the top and bottom heaters’ output throughout
the reflow process.

ThermoFlo ® TF1800

PACE’s ThermoFlo Systems’ patented Inductive- PN: 8007-0574 (120 V), 8007-0575 (230 V)
®
Convection Heating Technology reaches the target The TF1800 includes 1500
temperature in just seconds for safe, rapid solder joint Watts of total power. Can
reflow in virtually any component installation or removal work rework PCBs up to 12”
application, while using only a fraction of the power required x 12” (305mm x 305mm).
by yesterday’s conventional heating technology. The units Includes an adjustable
contain PACE’s latest advanced Profiling Software, a 1080p bottom-side pre-heater with
Vision Overlay system for precise component placement 1000 Watts of power and
and much more... an adjustable height of 1.5”
(38mm).
The Inductive Convection
Heater pre-heats the air in a
cyclonic fashion around the
induction coil before entering
the inner chamber, where the air TF2800
is instantly heated to the target PN: 8007-0582 (120 V), 8007-0583 (230 V)
temperature. The low thermal
mass design then allows the coil The TF2800 inlcudes 2400
to cool down at a faster rate, Watts of total power. Can
consistently yielding high quality rework PCBs up to 24” x
solder joints. 24” (610mm x 610mm).
The bottom-side pre-heater
includes a 1000 Watt central
heater and (6) 150 Watt
To view a complete list of Heat-Focusing Nozzles
available for the ThermoFlo Systems Please visit periphery heaters that can be
®
Paceworldwide.com for more information. independently controlled.