Page 312 - weller

Side cutters and tip cutters

Cut shape

There are three blade options, which determine the
Semi Flush SF
shape left on a lead after cutting.

Flush F

Semi Flush SF
Super Full Flush FF
Semi-flush Super full flush
This cut leaves a pyramidal tip at Only Erem offers you a super full flush cut.
Flush F
the end of the wire. It is particularly This cut provides absolutely flush wire
suitable for standard jobs where the ends.
Super Full Flush FF final shape does not play a significant No rework is needed. Cutters with this cut
role. Cutters with this cut are suitable are absolutely precision-ground and
Semi Flush SF
for both soft copper wires and very sharpened. The effort exerted when
hard wires such as stainless steel. cutting is low, as is the load on the
component caused by the cut. Soldering
Flush F tags in soldering-bath procedures are
Flush prevented. Cutters of this type are used
Super Full Flush FF This cut leaves a much smaller tip at the in applications for microelectronics,
end of the wire than the semi-flush cut – space travel or medical technology.
without reducing the cutting ability. The These cutters are suitable for soft wires.
cutting edges are finer than on semi-flush
cutters. The effort exerted when cutting
is less and the load on the component
is reduced. Flush wire ends reduce VS
the effort needed to fit components on
printed-circuit boards. Erem guarantees
precise cutting even after frequent use. Erem Competitor

Service

Re-sharpening Replacement parts
Erem is your service partner. All Erem side and tip cutters Erem cutters and pliers and their component parts are
except those with carbide insert blades can be re- warranted against manufacturing defects. Magic springs,
sharpened upto three times. Carriage charges will apply. precision joint components are available as spare parts.

312 Precision Tools